Q7.Correspondence Between Local Recording Quality and Encoding Settings - Decoder Series - kiloview

Q7.Correspondence Between Local Recording Quality and Encoding Settings

06/26/2026 / 425

Correspondence between Local Recording Quality and Encoding Settings

Issues and Objectives

**Help users better understand and configure reasonable recording parameters.
**

Problem Phenomena

  • Customer Scenarios:
    The recording automatically stops when using the encoder; the recorded video is choppy and unplayable; or the recording function is not visible on the encoder's webpage.
  • Trigger Conditions:
    **1.Inserting a USB 2.0 storage device for recording.
    2.Write protection is triggered due to overheating during the storage device's write process.
    3.Selecting the NDI HB (No recorder) mode.
    **
  • Root Cause:The recorded video uses H.264/H.265 encoding (if NDI HB encoding is selected alone, recording cannot occur). The encoding parameter settings are too high, exceeding the maximum write speed limit of the recording storage device.

Troubleshooting Process and Approach

Check Quality Settings and Storage Space:​ High-quality recording generates large files. Please ensure your storage device has sufficient free space. It is recommended to check the available storage space before starting a long recording session and leave ample headroom, as some storage devices may experience reduced write speeds when nearing full capacity.

2.Encoding Format Compatibility: While H.265 encoding offers higher compression efficiency, some older players and editing software may not support it. If you need to play or edit the recorded files on other devices, it is recommended to choose H.264 encoding to ensure compatibility.

##

3.Frame Rate Setting Recommendation: The frame rate setting should match the input signal's frame rate. For example, if the input signal is 30fps, setting the encoding frame rate to 60fps will not improve video quality but will instead increase file size. If set to 25fps, it may cause video stuttering.

4.Relationship Between Bitrate and Quality: Bitrate is a key parameter affecting video quality. A bitrate that is too low can cause mosaic artifacts and blurriness in the picture, while a bitrate that is too high wastes storage space. It is recommended to select an appropriate bitrate range based on your actual quality requirements.

5.Storage Device Performance:​High-quality recording places certain demands on the write speed of the storage device. It is recommended to use a Class 10 or higher SD card or a high-speed USB storage device. When purchasing a storage device, you can ask the vendor about its minimum sustained write speed across the entire disk. If this minimum speed is higher than the required recording bitrate, you must also ensure that the storage device does not overheat during recording to avoid dropped frames caused by the device's temperature protection mechanism being triggered due to high temperatures.

6.Check Encoder Mode: The N50/60 has a mode dedicated to streaming only NDI HB signals. When in this mode, it cannot simultaneously encode H.264/H.265 for local recording. Switching to another mode will enable recording.

Solution

Method 1:​ Set appropriate bitrates for different resolutions. For specific values, please refer to the table below.

Bitrate Frame Rate Resolution
6/10/25 Mbps 60fps 720P/1080P/4K
4/8/20 Mbps 30fps 720P/1080P/4K
3/6/15 Mbps 25fps 720P/1080P/4K

Method 2:​You can disable any unused streams, or reduce the encoding resolution and bitrate to keep the device's CPU and memory usage below 70%.

Method 3:​Set the GOP (Group of Pictures) to an integer multiple of the frame rate.

Method 4:​ Select another mode that supports recording.