Q10.Streaming is normal during debugging, but bonding streaming is laggy, with delayed video at the event site? - P-Series & Kilolink Server Pro - kiloview

Q10.Streaming is normal during debugging, but bonding streaming is laggy, with delayed video at the event site?

12/26/2025 / 672

A1. First, check the on-site network status and SIM card data balance.

  • Troubleshooting Reason: Weak network signal at the event site (e.g., indoors, basement obstruction), exhausted SIM card data, or speed throttling can cause insufficient bonding link bandwidth. The device doesn't directly display "signal strength dBm value," but link stability can be inferred from "Uplink/Downlink Rate" and "Latency ms" (Rate consistently below 1Mbps or Latency above 500ms usually indicates poor signal or insufficient bandwidth).
  • Solution: 1. On the LCD screen "Bonding" interface, check the "Uplink Rate," "Downlink Rate," and "Latency ms" for each link (4G/5G/Wi-Fi): If a link's rate is consistently below 1Mbps or latency above 500ms, click to "deselect" it from participating in bonding. 2. Contact the carrier to confirm if the SIM card is throttled/out of data; replace with a local SIM card with strong signal and sufficient data if needed. 3. If wired network or stable Wi-Fi is available on-site, prioritize connecting to it and add it to the bonding link to improve stability.

A2. Check if the bonding buffer time matches the network jitter.

  • Troubleshooting Reason: Buffer time is less than the on-site network jitter value, causing video lag due to discontinuous data transmission.
  • Solution: Enter the Web backend "Bonding Settings." If low latency is not critical (e.g., non-real-time interactive scenarios), adjust the buffer time to "500ms-1000ms" (recommended to be greater than the "Network Jitter" value displayed on the device). Save and restart the bonding stream.

A3. Confirm if VBR is enabled, adjust encoding parameters as needed.

  • Troubleshooting Reason: If VBR is not enabled, fixed bitrate (CBR) is prone to lag during network fluctuations. If VBR is enabled but the maximum bitrate is set too high, it may still exceed the available bandwidth.
  • Solution: 1. Enter "Encoding Settings," enable "VBR" (prioritizes smoothness in weak network environments), and set a maximum bitrate limit (e.g., 8-10 Mbps for 1080P, 20-25 Mbps for 4K). 2. If the network environment cannot be improved, reduce the encoding resolution (e.g., 4K→1080P) or frame rate (60fps→30fps) to reduce bandwidth pressure.