Release Date: 2025.4.2 Version: 1.10.0005

New Features:

1、 Support sub-stream configuration
2、 In MIX mode, added 9:16 resolution sizes to source options
3、 Added screenshot API: {ip}/api/codec/{hdmi/sdi/pip}/venc/snap
4、When encoding does not comply with NDI HX protocol standards, added prompt and one-click recovery shortcut operation
5、SRT protocol supports up to versions 1.5.3 and above
6、 Web interface default language adjusted to English
7、Default time configuration changed to NTP synchronization (takes effect after factory reset)

Version Optimizations:
1、Fixed issue where intermittent interrupt errors caused audio loss
2、Fixed issue where RTSP HTTP tunnel ports could not be used
3、Fixed issue where changing bitrate on the main interface only modified CBR bitrate
4、Fixed issue where uppercase letters in RTMP URLs might cause target address mismatch
5、Compatibility with RTMP platforms where stream ID is 0

Notes:
1、 The TS - udp, HLS, SRT, NDI - HX, and RTP protocols do not support G.711a/u audio encoding.
2、If you downgrade from this version to an older one, there may be an encoding failure problem caused by the incompatibility of the configuration files. You can solve this problem by restoring the factory settings.
3、 When there are no restrictions on the size and duration of the recorded files, you need to ensure that there is enough disk space. Alternatively, you can select the recording strategy of stopping recording when the space is insufficient.
4、When the cyclic deletion of recorded files is enabled, the system will preferentially delete the old recorded files in the corresponding directories (HDMI/SDI/MIX).
5、Due to the influence of the Internet on the NDI bridge, when the network is congested, there will be audio - video out - of - sync. When the network returns to normal, the audio - video out - of - sync will automatically recover.
6、After restarting the device or inserting a storage device, it will be slow to open the recorded files on the storage device for the first time.