Version: v1.10.0095

Firmware Instructions:
Currently, web-based firmware updates and upgrades are supported. If your software version is 1.10.0084 or higher, you can upgrade the firmware by uploading the "firmware-NDICORE-kiloview-xxxx.bin" file through the WEB background. If the version is lower than 1.10.0084, use the "install-kiloview-ndicore-xxxxx-20250311.tar.gz" file to install and upgrade the firmware.

New Features:
1.The hardware version of NDI CORE MAX has added the primary and standby function.
2.Added the function to modify the output order in panel management.
3.Added the pre-parsing function for input sources.
4.Compatible with the old API interface of version1.10.0079.

Optimized Features:
1.Optimized the installation and deployment script of NDICORE MAX.
2.Updated the NDI version to 6.0.1.

Fixed Issues:
1.Fixed the problem of incorrect network port order caused by the new optical fiber hardware.
2.Fixed the problem of abnormal output caused by the tally signal light.

Precautions:
1.To join the primary and standby group, devices must be on the same local area network, and the model, version, standby group number, and system time zone must be consistent.
2.When the pre-parsing mode is enabled, all inputs added to the matrix will be pre-parsed, and the delay in switching sources will be lower in this mode. When this mode is disabled, all inputs added to the matrix will not pre-parse resources, and the parsing will only be carried out when it is detected that this source is pulled for output. This mode can greatly reduce the bandwidth required for transmission, but there is a chance that it will increase the delay in switching sources.