If users change parameters that lead decoder can’t work (The typical situation is changed network address, so it can’t login decoder), users could restore factory setting to default value.
There are two ways to restore the factory settings. Restoring the factory settings will lead to a hard restart of the device. The restart process will take about 3 minutes.
-
WEB page "Restore", click to take effect.
-
RESET button of device panel. At the RESET button position of the device, hold down the reset key and keep for more than 5 seconds. The device will be restored to the factory settings.
Below parameters will be restored after restoring factory setting:
- Login username and password will be turned to admin;
- The IP address of Ethernet port 1 will be restored to 192.168.1.168/24, and the IP address of Ethernet port 2 will be restored to 1.168.2.168/24;
- All the video/audio decoding settings will be restored;
- Streaming settings will be restored.